A.3 Software; A.3.1 User Interface - AOIP THERMYS 150 Mode D'emploi

THERMYS 150 G
ENERAL
A.3 Software
The firmware of the THERMYS 150 is stored in flash memory. It is therefore relatively easy to update the firmware when a new version is available. Refer to
paragraph A.5.1 for detailed information on updating the firmware.
A.3.1 User Interface
The basic items forming the user interface are shown in the diagram below:
The "on-line help" function is not visible in the menu, but is accessible at any time by pressing the
use appears. The key closes the help window and all the dialogue boxes displayed.
The main menu is located at the bottom of the screen, opposite the four function keys (F1 to F4). To select an item from the menu, press the associated
function key.
Navigation within menus and sub-menus is by means of the navigation keys and the ENTER key.
For example, to open the Memory
1) Press the F3 key associated with the proposed Memory from the main menu.
2) Press the Down navigation key twice to select the Predefined settings sub-menu and confirm with the ENTER key.
3) Use the numeric keypad to enter the block size.
4) To go to the next field, press function key F1
5) To define the sampling period, press function key F3
and press ENTER (or press function key F3
6) Repeat...
It is possible to cancel the selection at any time and return to the main menu by pressing the ESC key.
The dialogue box interface is intuitive. It is managed by the function and navigation keys.
64/107
menu and configure the memory functions in the example shown in the screen below, perform the following steps:
.
).
to open the drop-down menu, then use the navigation keys (
key. When active, a help window for the function in
or ) to select the time