A.5.3 Cleaning - AOIP THERMYS 150 Mode D'emploi

THERMYS 150 G
ENERAL
To adjust the THERMYS 150, use the ADJUST function key. Make adjustments in the following order:
• V1 measurement: run all calibration procedures
• V2 measurement: run all calibration procedures
• CWC channel 1
• CWC channel 2
For each type of calibration, select the function to be calibrated with the Up and Down navigation keys and follow the instructions shown in the dialogue boxes.
When a unit is calibrated, data and certificate no. may be defined.
• Date of calibration
To change the date of calibration and enter the reference of any calibration certificate, use the ADJUST
A.5.3 Cleaning
In order to use the unit in complete safety, users must carefully read paragraph A.4 (page 104) which, among other things, deals with safety before handling. It
is advisable also to read the following paragraphs:
A.1.2 Unpacking (page 60)
A.2.7 Batteries and charger(page 64)
A.5.3 Cleaning (page 71)
70/107
Date of calibration menus.