Preferences; B.10 Bluetooth® Interface Configuration - AOIP THERMYS 150 Mode D'emploi

THERMYS 150 A
DVANCED
B.9.3

Preferences

To display the Preferences dialogue box, use the Configuration
The adjustable parameters are:
Filtering: Used to average measurements before display. When filtering is switched off, the integration time for measurements is 0.5 seconds.
Resolution: Used to adjust the resolution of the measurements when displayed. There are three possible choices:
• HIGH: displays measurements with the highest possible resolution.
• AVERAGE: displays one digit fewer compared with the HIGH resolution mode.
• LOW: displays two digits fewer compared with the HIGH resolution mode.
Temperature units: used to select the temperature units, either °C, °F or K, for measurements and simulation.
Lighting: used to set the on time of the lighting before it is switched off to save the batteries.
Beep keys: used to switch on or off the transmission of an audible signal when pressing keys on the keyboard.
Language: used to select the language of the display in menus, dialogue boxes and on-line help.
B.10 Bluetooth® Interface Configuration
The Bluettoth® module is enabled with the F1 key MENU
A name may be assigned to a unit connected to a Bluetooth® network with the F1 key MENU
100/107
O
PERATION
Setup Preferences... menus.
Bluetooth ON
Setup Bluetooth Name local.