A.2 Material; A.2.1 General View Of The Unit; A.2.2 Sheath; A.2.3 Connection Terminals - AOIP THERMYS 150 Mode D'emploi

THERMYS 150 G
ENERAL
A.2 Material
General characteristics:
• Portable unit powered by a pack of Ni-MH.
• Battery life: about 6 hours, depending on the functions used.
• Stand for table mounting.
• Strap for carrying and on-site use.
• 240 x 320 pixel liquid crystal graphical display.
• Choice of language for messages and programming the functions, settings and parameters using a keyboard with 22 keys.
• Back-lit display controllable from a key on the keyboard, with automatic switch-off after a programmable time of inactivity.
• Battery charging: mains adaptor supplied with the unit or from any 10 to 14 VDC power supply.
• Adaptor characteristics: mains voltage 230 V ± 10%, 50/60 Hz.
• Charging time: 4 h max.
• Case: ABS case with rubber sheath.
• Dimensions: 210 mm x 110 mm x 50 mm.
• Weight: 900 g with sheath and accessories
• Waterproof to IP 54 in accordance with standard EN 60529
A.2.1 General view of the unit
A.2.2 Sheath
The THERMYS 150 is delivered with a rubber sheath fitted to the case. The sheath protects the unit from mechanical shocks and makes the side openings for the
USB interface connector and the charger connector waterproof to IP54.
A.2.3 Connection terminals
Four terminals for channel 1 (C1) measurement function connection (IN); two of these terminals are reserved for 3-wire or 4-wire connection for resistance
measurement and for temperature measurement with a resistive probe. Refer to paragraph B.2.
Four terminals for channel 2 (C2) measurement function connection (IN); two of these terminals are reserved for 3-wire or 4-wire connection for resistance
measurement and for temperature measurement with a resistive probe. Refer to paragraph 2.
Note:
The screen printing of the terminals is the same as that of the CALYS 150, as the THALYS 150 can be upgraded to a multifunction process
calibrator (CALYS 150). This reconfiguration can only be carried out in the factory.
60/107