Advanced Operation; B.1 Simulation Modes; B.1.1 Manual Edit Mode; B.1.2 Incremental Edit Mode - AOIP THERMYS 150 Mode D'emploi

B. A O
DVANCED PERATION
B.1 Simulation Modes
Several transmission modes are available in the THERMYS 150 to facilitate rapid checking and calibration of instruments and transmitters.
To change the transmission mode, open the transmission window using the OUT function key (F2).
When the transmission window is open, the THERMYS 150 is set by default to the Manual edit mode.
To access the other modes, select the Mode menu using function key F4. Select a transmission mode using the Up/Down keys of the navigator and confirm with
ENTER.
To exit a transmission mode and return to the default mode, press the ESC key.
B.1.1 Manual Edit Mode
In this mode, the value to be transmitted may be entered directly using the alphanumeric keys.
The value entered appears at the bottom of the transmission window during entry.
To cancel the entry, press the ESC key. To transmit the value entered, confirm with the ENTER key.
B.1.2 Incremental Edit Mode
When this mode is active, the
Use the 4 navigator keys to edit the value to be transmitted.
To select a digit, use the Left and Right
To increment/decrement the digit selected, use the Up
icon appears in the transmission window.
keys of the navigator. The editable digit appears reversed in the display (white on black).
or Down key of the navigator.
Simulation Modes
Setting entered
manually
B
77/107