Publicité
CAUTION: The spark plug must be firmly seated. A loose spark plug can become very hot and
damage the engine.
Cleaning the motor
If the engine was previously running, allow it to cool down for at least half an hour before you start
cleaning. Regularly remove the accumulated dirt from the engine.
CAUTION: DO NOT spray the engine with water for cleaning. The water could contaminate the
petrol. Using a garden hose or pressure washer can flush water into the exhaust port. Water can
enter the cylinder via the exhaust and cause damage.
WARNING! The accumulation of foreign objects around the exhaust can cause a fire. Check
and clean it before each use.
Storage out of season
For engines stored for longer than 30 days, the fuel must be drained to prevent ageing and gum
deposits in the fuel system or in essential carburettor components. If the petrol ages during storage
in the engine, you may have to repair or replace the carburettor or other components of the fuel
system.
•
Remove the petrol by running the engine until it runs out.
•
Change the engine oil.
•
Remove the spark plug and empty about 30 ml of clean engine oil into the cylinder through the
spark plug opening. Pull the starter handle several times to distribute the oil. Then reinsert the
spark plug.
•
Clean deposits around the engine and under/around/behind the exhaust. Apply a light film of oil
to areas that are susceptible to rust.
•
Store the machine in a clean, dry and well-ventilated place, away from any appliances that
work with an open flame or pilot light.
Avoid rooms in which spark-producing electric motors or electrical appliances are used.
•
If possible, avoid rooms with high humidity.
•
Store the engine level. Tilting the engine can lead to petrol or oil leaks.
Maintenance of your snow blower
Maintenance of the milling auger
The augers are secured to the spiral axles with two shear pins with nylon hexagon nuts. If the augers
collide with a foreign object or a block of ice, the snow blower is designed so that the pins shear off.
If the auger does not rotate, check whether the pins are bent. If necessary, replace them with new
shear pins.
IMPORTANT: NEVER replace the shear pins of the auger with standard pins or holders. Any
resulting damage to the gearbox or other components is NOT covered by the warranty
Manual_FX-SF210_Int24_rev14
141
Publicité
