Publicité
63. Stopping the motor
The procedure for switching off is the same for manual starters and electric starters.
WARNING: To avoid unexpected movements of the snow blower, never leave the engine
running unattended. Release the throttle lever and reduce the engine speed. Leave the engine
running for a few minutes to dry out any moisture in the engine.
•
Switch off the motor after use by removing the key plug (2).
•
Wipe away any moisture from the control unit on the motor.
64. Engage forward or reverse gears
Important: Please only shift gears when stationary (release drive lever "A"). If this is not
observed, considerable damage can be caused.
•
Set the throttle lever to "FAST" (Hare).
•
To change gear, pull the gear lever fully towards you and push it into the desired position. Your
device has 2 reverse and 4 forward gears, which have different ratios and therefore different
movement speeds.
•
Only press the drive lever "A" down once the gear change has been completed. The machine
starts moving depending on the selected gear.
65. Starting the milling auger
To start the auger, press the auger drive "D" all the way down. To stop the auger, release the auger
drive "D" by letting go of it.
Manual_FX-SF210_Int24_rev14
132
Publicité
