Publicité
66. Problem solutions
Problem
Engine does not
start when cold
Engine runs
unevenly
Motor overheats
Power loss
Strong vibrations
Device does not
drive itself
Milling auger
continues to rotate
Manual_FX-SF210_Int24_rev14
Reason
-
Fuel tank is empty or
poor quality petrol
-
Blocked fuel line
-
Spark plug cable
disconnected
-
Defective spark plug
-
Engine flooded due to
excessive suction
-
Choke is set to
-
Engine runs with choke
-
Fuel tank is almost empty
or poor quality petrol
-
Water or dirt in the fuel
system.
-
Carburettor not adjusted
correctly.
-
Carburettor not adjusted
correctly.
-
Ignition cable loose
-
Ventilation with petrol
cap blocked.
-
Loose parts or damaged
milling auger
-
Drive belt loose or
damaged
-
Cable not set correctly
Solution
-
Fill the tank with fresh
petrol
-
Clean the fuel line
-
Connect spark plug cable
-
Clean spark plug, readjust
gap or replace
-
Suction four times.
-
Wait at least 10 minutes
before starting the engine
-
the choke
Set
-
Set the choke to half
position until the engine
warms up
-
Fill the tank with fresh
petrol
-
See engine maintenance
-
See engine maintenance
-
See engine maintenance
-
Connect the ignition cable
correctly.
-
Clear the vent.
-
Stop the engine
immediately and
disconnect the ignition
cable. Check for possible
damage. Tighten all pins
and nuts. Repair if
necessary. If the problem
persists, take the appliance
to an authorised service
centre
-
Replace drive belt
-
Set the auger control cable
correctly. See "Adjusting
the auger".
133
to
Publicité
