Publicité
plate and reinsert the end into one of the upper holes in the plate.
•
Slide the protective cover back over the adjustment plate and lock the Bowden cable again on
the handle of the worm drive.
•
After you have tightened the Bowden cable, test whether the drive runs smoothly again.
NOTE: If the auger continues to rotate with the auger control disconnected, switch off the motor
and readjust the cable.
If the auger is reluctant to rotate during operation, the cable is too loose and the coupling end must
be turned anti-clockwise to reduce the slack in the cable. Follow the steps above to readjust the
coupling end of the cable.
WARNING! Do not overstretch the cable. Overtensioning can prevent the auger from loosening
and jeopardise the safety of the snow blower.
Manual_FX-SF210_Int24_rev14
129
Publicité
