Publicité
•
Insert new sliding carriages and secure them with the old screws. Ensure that the sliding
carriages are evenly aligned.
Removing the scuff plate
•
Remove both sliding carriages as well as the connecting pins and nuts that hold the scuff
plate to the milling auger housing. You can see the position of the scuff plates in the
picture above.
•
Insert the new scuff plate and make sure that the heads of the connecting pins are
inside the housing.
•
Reinstall the sliding carriages. Tighten all connections.
Storage out of season
If the snow blower is not used for more than 30 days or the end of the snow season has
been reached, the device must be stored correctly. Follow the storage instructions to ensure
performance for many years.
•
Store the appliance in a clean and dry place.
•
If you store the appliance in an unventilated place, check the machine for rust by coating
the cutter with light oil or silicone.
•
Clean the outside of the motor and the snow blower.
Manual_FX-SF210_Int24_rev14
136
Publicité
