Publicité
three-wire connection to prevent the risk of an electrical short circuit. Read all explanations before
using the electric starter.
If your domestic power supply is earthed but does not have a three-wire connection, you should
have one installed by an electrician before using the electric starter.
If you have an earthed three-wire connection, proceed as follows:
-
Make sure that the key (2) is inserted
-
Set the throttle lever (3) to increased engine speed (hare).
-
3
Set the choke to
throttle to position
-
Press the primer pump (5) three to five times. If the engine is warm, only press the primer pump
once or twice. In cool weather, priming may have tobe repeated.
-
5
Connect the power cable to the control box on the motor. Plug the other end into an
earthed three-wire socket with 230V AC.
-
Press the electric starter button(8) on the control box to start the motor. Continuous pressing
can damage the electric starter. Release the button immediately once the motor is running. The
electric starter is equipped with thermal overload protection; the system will temporarily shut
down and allow the starter to cool down if the electric starter is overloaded.
-
When the engine warms up, slowly move the choke switch (1) to the position
jerks, restart the engine and set the choke to the half position for a short time and then to
the
position once the engine has warmed up.
-
When disconnecting the power cable, first unplug the end at the socket and then the end at the
snow blower.
Manual_FX-SF210_Int24_rev14
(for cold starts). When the engine is or becomes warm, set the
131
. If the engine
Publicité
