Publicité
60. Mounting the snow blower
•
Fit the lower part of the linkage to the frame using
the screws supplied. Use an open-end spanner for
this.
•
Hold the upper linkage in alignment with the holes. Slide the screws inwards from the outside.
From the inside, first place the washer and then screw the two rods firmly together with the
plastic rotary knobs.
CAUTION: Be careful
- Do not bend or kink cables
bend
•
Carefully slide the ejection chute
onto the chassis.
Manual_FX-SF210_Int24_rev14
124
Publicité
