Publicité
•
Loosen the hexagon nuts and carriage bolts. Adjust the skids to the desired position.
•
Make sure that the entire lower surface of the skid presses on the floor to avoid uneven wear of
the skids.
•
Reattach the nuts and bolts.
Shear pin
A spare pair of shear pins and nylon lock nuts are included with your snow blower. Store them in a
safe place until you need them.
Cleaning tool for the ejection chute
The cleaning tool is attached to the top of the auger
housing with a retaining clip and a cable tie. Cut the
cable tie before operating the snow blower.
Tyre pressure
The correct tyre pressure is between 1.0 bar and 1.4 bar. Check the tyre pressure regularly and
always set the same pressure in all tyres. Over-inflation (over 1.4 bar) can cause the tyre to burst.
The resulting forces can lead to serious injuries. Use a manual pump or a portable electric pump to
avoid over-inflating the tyres.
NEVER USE AN AIR COMPRESSOR
Manual_FX-SF210_Int24_rev14
126
Publicité
