Publicité
67. Maintenance and cleaning
General recommendations
•
Follow the safety rules for all maintenance.
•
The warranty does not cover damage resulting from misuse or negligence. To obtain the
full scope of the warranty, the user must maintain the snow blower as described in
these operating instructions.
•
Check regularly that all fastenings and system parts are tight.
WARNING! Before servicing, repairing, lubricating or checking, disconnect all controls
and switch off the motor. Wait until all moving parts have come to a complete standstill.
Remove the ignition cable and earth it to the engine to prevent unintentional starting.
Always wear safety goggles during work or when servicing or making adjustments to the
machine.
Engine
General recommendations for the maintenance of your motor are listed below. For further
details, please contact the manufacturer.
•
Check the oil level before starting work.
•
Change the engine oil after the first 5 hours of operation and then every 25 hours.
•
Clean the spark plug at least once per season or every 100 working hours and reset the
electrode gap to 0.7 mm; replace the spark plug every 200 working hours.
Wheel air pressure
Before starting work, check the air pressure and set it to 1.0 to 1.4 bar. Read the "Fitting"
and "Settings" sections of these operating instructions for the correct inflation process. If the
air pressure in both tyres is not the same, the device may pull in one direction.
Scuff plate and sliding carriage
The scuff plates and the sliding carriages at the end of the snow blower are used parts. They
should be checked regularly and replaced if necessary.
Replacing the sliding carriage
•
Remove the connecting pin and nut from each sliding carriage on the milling worm
housing.
Manual_FX-SF210_Int24_rev14
135
Publicité
