Pays/Région
Royaume-Uni
États-Unis, Porto Rico
Viêt Nam
Zambie
Cette version du manuel est valable au moment de son impression, mais cette validité ne peut être entièrement garantie pour l'avenir. Pour plus
d'informations, consultez la première page, qui comporte un avertissement complet.
Type
Conformité
d'homolo-
gation
WAN00,
UWB Reader (UWBR)
YBN00
Model: WAN00
Manufacturer: DENSO CORPORATION Address: 1 1, Showa-cho, Kariya-shi, Aichi-ken,
448 8661 Japan
Operation frequency: CH5: 6240.0 - 6739.2 MHz. CH9: 7737.6 - 8236.8 MHz. Maxi-
mum output power: -41.3 dBm/MHz or less
Radio Frequency Key (RFK)
Model: YBN00
Hereby, DENSO CORPORATION declares that the radio equipment type is in com-
pliance with Directive 2014 53 EU. The full text of the EU declaration of conformity is
available at the following internet address:
s/doc/ [https://www.denso.com/global/en/contact-us/doc/]
Hereby, DENSO CORPORATION declares that the radio equipment type is in com-
pliance with the relevant statutory requirements. The full text of the UK declaration of
conformity is available at the following internet address:
en/contact-us/doc/ [https://www.denso.com/global/en/contact-us/doc/]
Manufacturer: DENSO CORPORATION Address: 1 1, Showa-cho, Kariya-shi, Aichi-ken,
448 8661 Japan
UWB Operation frequency: CH5: 6240.0 - 6739.2 MHz. CH9: 7737.6 - 8236.8 MHz.
Maximum output power: -41.3 dBm/MHz or less
Key system
Manufacturer: DENSO CORPORATION Address: 1 1, Showa-cho, Kariya-shi, Aichi-ken,
448 8661 Japan
Bluetooth Operation frequency: 2402 - 2480 MHz. Maximum output power: -41.3 dBm
or less
NFC Operation frequency: 13.56 MHz
Qi Operation frequency: 110 - 205 kHz
WAN00,
UWB Reader
YBN00
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause un-
desired operation.
Radio Frequency Key
NOTE: This device complies with part 15 and part 18 of the FCC Rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a wireless power
charger, pursuant to part 18 of the FCC Rules. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the ins-
tructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio communications, which can
be determined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the re-
ceiver is connected.
FCC Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the userʼs authority to operate the equipment.
Radiofrequency radiation exposure information: This equipment complies with FCC ra-
diation exposure limits set forth for an uncontrolled environment and meets the FCC ra-
dio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF
energy.
WAN00,
CÔNG TY TNHH SWEDEN AUTO. B2100176
YBN00
WAN00,
WAN00 ZMB ZICTA TA 2021 12 9
YBN00
YBN00 ZMB ZICTA TA 2023 3 4
https://www.denso.com/global/en/contact-u
https://www.denso.com/global/
474 / 487
Label