Christopeit Sport AL2 Instructions De Montage Et D'utilisation page 18

STEP 4
Attach the front post (12) at main frame (1).
1. Slide the handlebar support cover (11) onto the handlebar
support (12).
2. Hold the handlebar support (12) with the computer cable
(3) against the main frame holder. Connect the plug for the
computer cable (3) coming out of the bottom of the handlebar
support (12) of the computer with the matching plug for
the motor cable (16) coming out of the main frame (1).
Note: The computer cable harness (3) projecting from the
support (3) must not slide into the tube, as it is required for
later steps of installation.)
3. Place the handlebar support (12) in the locator provided
for it in the main frame (1). Ensure that the cable connections
made in step 3 are not squashed. When putting the steering
tube in place, push the former slowly down into the locator in
the main frame. Screw the handlebar support (12) onto the
base frame (1) with the screws (14), spring washers (15) and
washers (13).
4. Push the handlebar support cover (11) into right position
to cover up the screw connection point.
STEP 5
Attach the saddle (34) and saddle slide (33) at saddle sup-
port (29) and the saddle support (29) at main frame (1).
1. Push the saddle (34) with saddle bracket into the saddle
slide (33) and tight it up in desired position. To do this, both
black nuts must be tightened very firmly.
2. Place the saddle slide (33) into the holder of saddle
support (29), set it at the desired horizontally position and
screw it onto the saddle support (29) by fixing piece (6)
washer (32) and star grip nut (31).
3. Push the saddle support tube (29) into the matching
locator in the main frame (1), set it at the desired position
and lock it by inserting the bolt with the quick release
(30) in place and doing it up tight. (Note: To screw in the
rapid-action lock (30), the threaded hole in the main frame
(1) and one of the holes in the saddle support (29) must
be aligned. Furthermore, ensure that the saddle support
(29) is not pulled out of the main frame beyond the marked
maximum Position. The setting of the saddle post can be
adjusted as desired later. For this, the rapid action catch
(30) must be loosened by only a few revolutions, the cap of
the lock must be pulled away and the saddle adjusted. Then
secure the new setting by tightening the rapid action catch.)
Furthermore, you must ensure when setting this desired
position that the seat pillar is not pulled out of the main frame
further than the highest setting position, which is marked.
Attention! Ensure before every exercising that the saddle is
tighten firmly.
12
11
13
3
1
18
14
15
16
33
34
34
6
29
30
1
GB
33
32
31