Christopeit Sport AL2 Instructions De Montage Et D'utilisation page 17

GB
ASSEMBLY INSTRUCTIONS
Remove all the separate parts from the packaging, lay
them on the floor and check roughly that all are there
on the base of the assembly steps. Please note that a
number of parts have been connected directly to the
main frame and preassembled. In addition, there are
several other individual parts that have been attached to
separate units. This will make it easier and quicker for
you to assemble the equipment. Assembly time: 30 - 40
min. 1
STEP 1
19
Attach the stabilizer (20) at main frame (1).
1. Put the end caps with transportation roller (18L+18R) at
15
the ends of shorter front foot (20) in appropriate position and
screw them tightly by using screw (71).
13
2. Attach the front foot (20) with the preassembled end caps
with transportation rollers (18) to the main frame (1). Do this
with the two screws (28), washers (13), spring washers (15)
20
18L
and cap nuts (19).
18R
71
28
STEP 2
Attach the stabilizer (27) at main frame (1).
1. Put the end caps with height adjustment (26) at the ends
of longer rear foot (27) and screw them tightly by using screw
(71).
2. Mount the rear foot (27) on the base frame (1) so that
19
the end caps stand properly on the floor. Do this with the
two screws (28), washers (13), spring washers (15) and
15
cap nuts (19). After assembly has been completed, you can
compensate for minor irregularities in the floor by turning the
wheel at cap (26). The equipment should be set up that the
13
equipment does not move of its own accord during a training
session. If you like to change the position of the home bike,
put one foot in front of the front foot (20) and pull at handlebar
1
in front direction until the home bike can move easy on the
transportation rollers to another place.
26
26
28
71
27
STEP 3
Attach the pedals (22L+22R) at pedal crank (21L+21R).
21L
89L
1. Screw the right pedal (22R) into the pedal arm (21R),
22R
which is on the right-hand side in the cycling direction.
22L
(Attention! the screw direction is clockwise).
2. Screw the left pedal (22L) into the pedal arm (21L) on the
left hand side in the cycling direction. (Attention! the screw
direction is anti-clockwise.) The assignment of the individual
21R
parts has been simplified for you by an additional marking
with the letter R for right and L for left.
89R
3. Then mount the pedal straps (89L+89R) left and right on
the associated pedals (22L+22R).
17