Publicité
EasyClean free Auto Mix and EasyClean Auto Mix & Pump
The control unit can only be opened if the main switch is
in the OFF position (1).
Undo screws in the housing cover and lift up the housing
cover.
Install the housing in the planned spot, using all 4 fixing
options.
Take the ambient conditions into account.
4.5
Installing the solenoid valve(s)
Valid for the versions: EasyClean free Auto Mix and Auto
Mix & Pump
Identify supply pipe(s) for refill inlet (d = 1").
Switch off water supply.
Cut through the pipe, cut threads into both sides.
Loosen the screw for the connector plug.
Pull the connector plug off.
Fit the solenoid valve in the pipe (horizontal direction),
check for a tight fit.
Fit the connector plug again analogue to its removal.
The solenoid valves are normally closed.
4.6
Installing the manual valve
Valid for the versions: EasyClean free Mix and Mix & Pump
Identify supply pipe(s) for refill inlet (d = 1").
Switch off water supply.
Cut through the pipe, cut threads into both sides.
Fit the solenoid valve in the pipe (horizontal direction),
check for a tight fit.
.
4.7
Connecting the Storz-B coupling
Connect the Storz-B coupling to the riser pipe/disposal pipe provided by the customer.
If the Storz-B coupling is to be positioned at some distance outside the building, the KESSEL disposal chamber (acces-
sory) can be used for this.
58 / 132
Installation and operating instructions
016-673
Publicité
