Publicité
Person
1)
Competent expert /
inspector (familiar with,
understands oper-
ating instructions)
Competent skilled per-
son (specialist crafts-
man, in accordance with
installation instructions
and execution standards)
General inspector (in
accordance with EN 1825)
Qualified electrician (accord-
ing to national regula-
tions for electrical safety)
1) Operation and assembly work may only be carried out by persons who are 18 years of age.
2.3
Intended use
The product is a system for separating grease out of domestic or commercial wastewater per DIN EN 1825. Greases are
substances of vegetable origin and/or animal origin with a density of less than 0.95 g/cm3, which are partially or completely
insoluble in water or saponifiable. Disposal and maintenance cycles as well as requirements concerning the installation site
must be complied with for proper operation.
All:
modifications or attachments
use of non-genuine spare parts
Repairs carried out by companies or persons not authorised by the manufacturer can result in a loss of warranty.
2.4
Product description
Versions: EasyClean free Standard and EasyClean free Direct
The EasyClean free Standard is suitable for free-standing installation in frost-protected rooms and is manufactured without
the need for metallic structural components in the tank. The collection tank made of permanently resistant polymer (PE) is
equipped with an integrated sludge trap and has sloped sides in the base to promote fast and efficient disposal. Two odour-
tight covers with quick-release closures make easy access possible for cleaning and maintenance work. Manual disposal
takes place with the tank open.
The EasyClean free Direct is equipped with a direct disposal pipe, to which a permanently installed disposal pipe can be
connected. The contents of the tank can be very easily emptied via this pipe by the disposal vehicle's pump, without having
to open the tank. It is preferably cleaned and flushed with hot water through the maintenance openings.
016-673
Approved activities on KESSEL systems
Emptying, clean-
ing (inside), func-
tional check
Installation, replace-
ment, maintenance
of components,
commissioning
Fig.: EasyClean free Direct
Installation and operating instructions
Leak test, checking
on correct design and
proper assembly before
initial commissioning
Work on electrical
installation
47 / 132
Publicité
