Publicité
Versions: EasyClean free Mix & Pump and EasyClean free Auto Mix & Pump
The EasyClean free Mix & Pump offers a pump for disposal and flushing, a shredder-mix system for circulation and
homogenisation of the tank contents, a control unit for the program run and a direct disposal pipe. The contents of the closed
tank are disposed of through permanently installed pipes into the disposal vehicle with the help of a pump.
The EasyClean free Auto Mix & Pump offers program-controlled, fully-automatic disposal and flushing equipment, a shred-
der-mix system, disposal pump, direct disposal pipe and control unit. The contents of the closed tank are disposed of
through permanently installed pipes into the disposal vehicle. The system's own pump is used if the disposal pipe is so long
that the disposal vehicle's suction pump is not sufficient. The shredder-mix system is used to circulate and homogenise the
contents of the tank for easy disposal.
Conversion of the system for a higher degree of automation of the disposal process is possible with specific retrofit kits.
Pos. no.
(1)
(2)
(3)
(4)
(5)
(6)
(14)
(7)
(8)
(15)
(9)
(10)
(11)
(12)
(13)
50 / 132
Fig.: EasyClean free Auto Mix & Pump
Component
Shredder-mix pump
2-way valve and actuator for flushing and disposal pipe
Inlet
Connect 400 V grease separator control unit
Service access cover (inlet side)
Solenoid valves for hot and cold water (EasyClean free Auto Mix & Pump only)
Manual valve (EasyClean free Mix & Pump only)
Refill inlet
Direct disposal pipe
Inspection window
PT-screw 100x30 A2
Service access cover (outlet side)
Outlet
Shut-off valve for pump removal
Lifting points (on both sides), see "Transport information", page 56
Eyebolts, see "Transport information", page 56
Installation and operating instructions
016-673
Publicité
