Publicité
en Operation
Designa-
Use
tion
Recommendation for a per-
fect result:
¡ Use cream with a min-
imum fat content of 30%
and a temperature of
4-8 °C.
Cutting discs
Designa-
Use
tion
Reversible
Cutting food into thick or
cutting
thin slices, e.g. fruit and ve-
disc, thick/
getables.
thin
Marking:
¡ COARSE = thick slices
¡ FINE = thin slices
Note: Not suitable for pro-
cessing hard cheese, bread,
rolls or chocolate.
Tip: Only cut up cooked
potatoes once they have
cooled down.
Reversible
Shredding food coarsely or
shredding
finely, e.g. fruit, vegetables
disc,
or cheese as Gouda or
coarse/fine
Edam.
Marking:
¡ 2 = coarse side
¡ 4 = fine side
Note: Not suitable for pro-
cessing nuts or hard
cheese, e.g. Parmesan.
Tip: Shred soft cheese with
the coarse side only.
Reversible
Grating raw potatoes or cut-
slicing /
ting into slices.
shredding
Note: Not suitable for pro-
disc
cessing very fibrous foods,
e.g. leek or mango.
30
Safety systems
Start lock-out
Start lock-out prevents your appliance from
being switched on accidentally.
You can switch on and operate the appli-
ance once the bowl has been correctly po-
sitioned and the lid is locked.
Note: If the bowl becomes detached or the
lid is opened, the appliance automatically
switches off.
Overload protection
The overload protection system prevents
the motor and other components from be-
ing damaged through being overloaded.
Operation
Operation
Operation
Setting up appliance
1.
Place the appliance on a stable, level,
clean and flat work surface.
Adjust the power cable to the required
2.
length.
– To shorten the cord, push it into the
cord storage compartment.
– To lengthen the cord again, pull it out
of the cord storage compartment.
3.
Do not insert the mains plug.
Attaching the bowl
Tip: Always hold the bowl straight when
placing it on the main unit.
2
6
→ Fig.
-
Processing ingredients with tools
Notes
¡ Always fit tools before adding ingredi-
ents.
¡ Fit the tool with the correct side facing up
and push down to the lower stop of the
tool holder.
Requirement: The bowl with the tool holder
is placed on the main unit.
→ Fig.
7
-
19
Publicité
