Operating Instructions Control Panel 3010 614 - Alde Compact 3010 Instructions D'utilisation

OPERATING INSTRUCTIONS CONTROL PANEL 3010 614

Please read these instructions carefully before using the boiler. For Operating and Installation Instructions of
boiler, please see separate instruction. These instructions are approved for the Alde Compact 3010 boiler fitted in
recreational vehicles, in accordance with ANSI 21.13-2014, CSA 4.9-2014.
Installation and repairs may only be carried out by a professional. National regulations must be adhered to.
1. Starting the boiler
1. The control panel and the boiler
are switched off.
2. The control panel in standby mode
D
72°F
C
B 42°F
A
Fri 18.30
G
3. From standby mode to setting menu
When on standby, the indoor temperature is displayed, and the outdoor temperature is displayed if an outdoor tem-
perature sensor has been connected. The background lights up when you press the screen or the MENU button. Start
the setting menu by pressing the MENU button. The background lights up and those functions which can be set are
displayed. The settings are automatically saved after 10 seconds. The control panel reverts to standby automatically
after 30 seconds if no buttons are pressed (or if the MENU button in the setting menu is pressed).
1. The control panel in standby.
72°F
42°F
Fri 18.30
10
E
A. Clock
The clock shows day and time. The
clock is set under section 9 point 2.
B. Outdoor temperature
The outdoor temperature is dis-
played if a sensor probe is installed.
C. Indoor temperature
The indoor temperature is displayed
automatically.
F
2. To start the boiler, press the On/Off button
and the start-up display is displayed. The
boiler starts with the last selected setting.
3010
NOTICE
If "Standby Brightness" is set to Off, the display
goes out when it enters standby mode, but lights up
if you press the screen. See settings under 9.9.
D. Circulation pump
E. 120 volts
F. MENU button
G. On/Off button
2. The control panel in setting menu.
72°F
2
ON
Off On
A green LED comes on beside
the On-/Off button when the
panel/boiler is on.
This symbol is displayed when the
circulation pump is requested.
This symbol is displayed when
120 V is connected to the boiler.
Button for setting menu.
Shut down / turn on the boiler.