Roland VS-2000 Mode D'emploi page 396

29—Possibilités d'extension du VS-2000
5. Replace the old battery with a new one.
The VS-2000 uses a lithium CR2032 battery that you can purchase at most electronics
stores.
If you suddenly release your finger after pressing the lithium battery
inward, the battery may fly out in the direction shown by the arrow (see
illustration at right). Release your finger gradually, being careful not to
allow the battery to fall inside the unit.
6. Use the screws that you removed in Step 3 to re-fasten the VS-2000's bottom cover.
7. Connect the cables that you disconnected earlier.
8. Turn on the power, as described in "Powering Up" on Page 65.
9. Confirm that the message saying the lithium battery is depleted no longer appears
The VS-2000's clock is powered by its battery. Changing the battery may stop the clock
or cause it to display the wrong time or date.
10. Reset the VS-2000's clock and calendar (Page 67).
396
Removal
2
1
Installation
2
1
This completes the process of exchanging the lithium battery.
in the display.
www.roland.fr
While pressing the lithium battery
1
inward in the direction of the arrow...
Use your finger to tilt the battery
2
upward and slide it out.
While holding the lithium battery
1
at an angle, insert it in the direction
shown by the arrow.
Press the battery down until it
2
is retained by the tabs.
Roland VS-2000 Mode d'emploi