Remplacement De La Pile Du Vs-2000 - Roland VS-2000 Mode D'emploi

Replacing the VS-2000's Battery
The VS-2000 contains a lithium battery that powers its time-keeping features, and also
provides the power for the area of the VS-2000's memory that stores certain parameter
values. When the battery weakens, the VS-2000's time-keeping features may not
operate correctly, and it may not properly remember various settings upon power-up. If
the battery needs to be replaced, the VS-2000 shows the following message when you
power up:
Use only the specified type (model no. CR2032) of lithium battery. Be sure to insert it as
directed (to ensure correct polarity).
Before turning the VS-2000 upside-down to install a new battery, obtain some
newspapers or magazines and place them under the four corners of the VS-2000, or at
both ends, to prevent damage to the buttons and controls. Position the VS-2000
carefully to avoid scratching or damaging it.
When installing a new battery, follow the precautions listed on Page 389.
Installation Procedure
1. Power down the VS-2000 (Page 85), saving any recent changes you've made to the
2. Turn off all connected devices, and disconnect all cables from VS-2000.
3. Turn the VS-2000 over onto its back, and remove only the screws shown in the
4. The battery should now be visible, as shown here.
Roland VS-2000 Mode d'emploi
currently loaded project.
following illustration.
29—Possibilités d'extension du VS-2000
Tab
EFFECT B
EFFECT C
Lithium Battery
www.roland.fr
Should you remove battery and
screws, make sure to put them
in a safe place out of children's
reach, so there is no chance of
them being swallowed
accidentally.
395