Publicité
Component Replacement Instructions
5.
Clean the exposed fastener threads of dirt and/or paint
before loosening. Loosen the V-Rod fastening hardware
attached to the crossmember center channel to reduce
binding during the end plate removal and installation
(Figure 54). DO NOT remove V-Rod hardware.
6.
Note the orientation (bolt head up) and position of the
crossmember fastening hardware that attaches the lower
end plates to the center channel. Remove and discard the
crossmember fastening hardware (Figure 55).
NOTE: The position of the hardware in the row on the
end plate is important to the suspension function
(Figure 56).
NOTE: Crossmembers may include washers.
7.
Make sure the faces of mating surfaces are clean to
ensure proper clamp load.
34
Figure 54
Figure 55
UPPER
END
PLATE
LOWER
END
PLATE
Figure 56
XL-PS10452MM-en-US Rev E · 2024-05-23 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND,
SAF,and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
V-ROD FASTENING
HARDWARE
FRAME
CROSSMEMBER
V-ROD
CROSSMEMBER
FASTENING
HARDWARE
Figure 18 - page 18
(Note: Pinion plates are now xed)
CROSSMEMBER
CROSSMEMBER
IN POSITION 1
IN POSITION 2
1 2 3
1 2 3
V-ROD
FASTENING
HARDWARE
REAR V-ROD
ATTACHMENT
BOLT
UPPER END PLATE
LOWER
END PLATE
CROSSMEMBER
IN POSITION 3
1
2 3
Publicité
