10. The suspension ride height should be within ± .25" (6 mm)
of the recommended design height. Refer to Section 6 for
further ride height information.
11. Weld-On Axle Adapter Bracket (Figure 7): The welds
connecting the axle adapter brackets to the axle MUST be
to the axle manufacturer's or vehicle OEM's specifications.
12. Check that the axle pinion angle (axle tilt) is within the
chassis builder's specifications. Refer to (Figure 8) for
definition of the pinion angle.
13. Ensure that SAF-HOLLAND
installed (Figure 9).
Failure to properly install axle stops
could result in component failure which,
if not avoided, could result in minor or
moderate injury.
14. Check the alignment of the suspension per vehicle OEM
instructions. If realignment is necessary, refer to the
alignment procedures described in Section 6.
XL-PS10452MM-en-US Rev E · 2024-05-23 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND,
SAF,and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
axle stops are properly
®
Figure 7
WELD-ON
AXLE ADAPTER
Figure 8
PINION ANGLE
SETTING RANGE
0°-14°
Figure 9
AXLE STOP
Pre-Operation
13