Operating Elements And Displays On Device; Drive - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
4.1
OPERATING ELEMENTS AND DISPLAYS ON
DEVICE
1
2 Selector switch for operating mode
3 Indicator light (Error)
4 Operating light (Power)
5 EMERGENCY STOP switch
POWER ERROR
4
3
5 2
The selector switch (Fig. 3, 2) offers the following modes:
"A" position = automatic
Basic setting for control with an automatic
A
mote control
"F" position = manual activation
A
This setting is required for:
When using the pneumatic lance, this set-
ting is also needed for:
"R" position = reverse gear (must be held in
this position).
A
This setting is required for:
0-10
SPEED
1
Fig. 3, 1) is used to regulate
Detailed explanation of selector switch use:
If the selector switch is in the "A" position, the PC830 can be
switched on and off with the material shut-off on the auto-
pump unit ), the machine is switched on using the "F" switch
position and off using the "A" position.
switched off to clean the mortar hose, the pneumatic lance
is not controlled using the material shut-off. In this case, the
machine must therefore also be switched on using the "F" po-
sition.
Important: control via the selector switch and
The machine can be switched from the "A" po-
sition (control using material shut-off ) to "F" at
person operate the machine.
The operating light (green, Fig. 3, 4) indicates that the machine
When the mains plug is connected the PC 830 carries out a
function check. While this is going on the indicator light (red,
stops after about 30 seconds. If the indicator light lights up
during operation, this indicates that there is a malfunction. For
detailed information about this kind of fault, refer to the „Rec-
tification of faults" section on page 46.
If the selector switch is in the "F" position when
the mains plug is plugged in, the machine will not
switch on.
to "F" to switch on the machine.
-
EMERGENCY STOP switch
When the EMERGENCY STOP switch is pressed, the PC 830 is
Turn the EMERGENCY STOP switch in order to release it again.
The machine remains switched off after release. To switch it on
to "F".
4.2

DRIVE

Move selector switch (Fig. 3, 2) to "A" and disconnect mains
The drive unit heats up during operation. This
is normal and not a sign of malfunction.
GB
OVERVIEW
35