GB
exPlanatory dIagram/ settIng and dIsPlays on the control Panel
2
eXPlAnAtory dIAgrAM (fIg. 1)
Pos. desIgnatIon
1
Nozzle
2
Air cap
3
Spray jet width adjusting lever (shaping air)
4
Spray jet level adjusting ring (vertical/horizontal)
5
Union nut
6
Spray attachment complete
7
Material volume regulation
8
Gun handle
9
Air volume control
10
Air hose
11
Click&Paint catch
12
Trigger (actuates turbine starting switch material is
conveyed)
13
Container (TempCup)
14
Mixer
15
Suction tube
16
Container seal
17
Valve
3
SettIng And dISPlAyS on the control PAnel (fIg. 2)
A
„30°C" button
B
„50°C" button
C
„Heat" button
D
„Clean" button
E
Control lamp (yellow)
F
Control lamp „Spray/clean"
(green)
G
Control lamp „Heating" (red)
Keep any button pressed for about 3 seconds to stop the heating or cleaning process
20
Setting to warm the paint to approx. 30°C (depending on the paint you are using).
Standard setting when switching on the device
Setting to warm the paint to approx. 50°C (depending on the paint you are using).
Starts the heating process
Starts the cleaning process
Indicates which temperature is selected
When both control lamps are flashing alternately, a function test is currently being run.
When both control lamps are flashing at the same time, an error has occurred (informa-
tion about the type of error and how to rectify it can be found in the chapter, „Correc-
tion of Malfunctions")
This lights up when the paint has reached the desired temperature
It remains lit during the cleaning process
It remains lit while the paint is being heated
FinishControl 6500 TS
Pos. desIgnatIon
18
Ventilating hose
19
Carry handle
20
Tool to change mixer
21
ON/OFF switch (I = ON, 0 = OFF)
22
Heating station
23
Control panel
24
Gun mounting for park position
25
Air filter cover
26
Air filter
27
Power cable
28
Air hose connection
29
Cleaning brush
30
Fine feed tube filter (red)
Coarse feed tube filter (white)
31
Funnel (3 pcs.)
32
Air hose fixing straps (2 pcs.)