Introduction To Working With The; Function Of The; Plastcoat 830; Processible Coating Materials - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
2
INTRODUCTION TO WORKING WITH
THE MORTAR SPRAYING MACHINE

PLASTCOAT 830

The suction pump PlastCoat 830 is conceived for using and
The machine is not designed for use as a cleaning device.
2.1
FUNCTION OF THE MORTAR SPRAYING MACHINE
PLASTCOAT 830
tric screw pump. The suction effect causes the coating materi-
al to enter the eccentric screw pump. This pump builds up the
pressure required for transportation through the mortar hose.
The compressed air required for atomisation is supplied at the
and off using the electric control. This can also be used to con-
2.2

PROCESSIBLE COATING MATERIALS

All the coating materials must be suitable for machine process-
ing. Refer to the product data sheet of the coating material to
be processed.
3

TECHNICAL DATA

Voltage:
Fusing:
Motor output P :
1
Max. operating pressure:
Max. granular size:
Dimensions L x W x H:
Weight (PlastCoat 830):
Weight ( ):
Degree of protection:
Max. sound pressure level:
Atomizing air connection:
Max. atomizing air pressure:
Minimum required compressed
air volume:
Max. mortar hose length:
* Place of measurement: 1 m distance from unit and 1.60 m
above reverberant floor.
GB
INTRODUCTION
PlastCoat 830
230 V~, 50 Hz
16 A time-lag
5 m long, 3 x 1.5 mm 2
1.8 kW
12 l/min
40 bar
K3 mm
1100 x 550 x 820 mm
45 l
52 kg
2.1 kg
2.5 bar
IP 55
70 dB (A)*
Rapid action coupling
DN 7.2 mm
10 bar
280 l/min
30 m (and 2.5 m hose
whip)
20 m
33