Preparing The; Rinse The Mortar Hose - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
6.8
PREPARING THE MORTAR SPRAYING MACHINE
(FIG. 16)
Recommended sliding means for the mortar hose
Water is not sufficient as a sliding means.
Danger of clogging!
paste, art no. 2312136)
The operation light (1) shows operational readiness.
Risk of injury from escaping material.
Before switching on, always check that the
material tap on the spray lance is closed
(material tap points forwards).
Close material tap whenever stopping
work.
6.8.1

RINSE THE MORTAR HOSE

(AUTOMATIC SPRAY LANCE)
Close the air flow regulator (fig. 17.2).
Do not bend the mortar hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
on.
If cellulose paste comes out of the tip, close the material tap
(fig. 17, 1) (material tap points forwards).
ceptacle to half full.
material.
close material tap (Fig. 17, 1).
1
2
-
2 3
1
GB
COMMISSIONING
41