Plast Coat 830
8.3
CLEANING THE SPRAY LANCE
Clean the texture tip.
Use cleaning needles to clean the air holes in the texture
tip.
a bottle brush (0342 329).
1
9
MAINTENANCE
ATTENTION! It is imperative that the machine be
work and maintenance work. Otherwise there is
a danger of short-circuiting!
sonnel who dispose the corresponding training
of care and maintenance is required. However, the following
work has to be carried out and components checked regu-
9.1
MECHANICAL MAINTENANCE
Keep the thread at the pump tube and pump housing
clean and, if appropriate, seal.
Check the seals at all the couplings and connecting pieces
for leaks. If appropriate, replace worn seals.
- Mortar hose
- Power cable
- Control unit
- Remote control connection cable (if present)
9.2
ELECTRICAL MAINTENANCE
short-circuits.
9.3
LONG PERIODS OF NON-USAGE
sion.
Remove the stator from the pump unit ensur-
ing that it cannot become set tat the rotor.
9.4
ROTOR REPLACEMENT (FIG. 21)
-
GB
MAINTENANCE
Danger of
-
1
2
45