Interruption Of Work; Shutting Down And Cleaning - WAGNER W550 Mode D'emploi

GB

Interruption of Work

i
When processing 2-component varnishes, clean the device immediately.

Shutting down and cleaning

Please also refer to the instructions of the basic device.
1) Switch the unit off. Vent the container in case of longer breaks and after the work has
been terminated. This can be done by briefly turning open and then closing the container
or by pulling the trigger guard and letting the paint into the original paint container.
2) Screw of the container and empty it. Pull out the suction tube with container seal.
3) Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 1, C).
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent, only wipe.
4) Pull the ventilating hose (Fig. 1 A, 12) at the top from the gun body. Screw off the valve
cover (13). Remove the diaphragm (14). Clean all the parts carefully.
5) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water.
Pos. Designation
3 Nozzle seal
4 Nozzle
5 Union nut
6 Air cap XL
Australia (AUS) version order no. in brackets
9 Container seal
10 Feed tube
11 Container 250 ml with cover
12 Ventilating hose
13 Valve cover
14 Diaphragm
15 O-Ring
16 Viscosity test cup
The new CLICK&PAINT SYSTEM with additional spray attachments and accessories
offers the richt tool for each work.
8
Spare Parts List (Fig. 1)
Small-scale spray attachment
Order No.
0414 353
0417 370
0417 319
0417 371
AUS (0417 376)
0417 358
0417 378
0417 922
2304 027
0417 308
0413 306