Assembling The Bag Support (Accessory) - WAGNER Plast Coat 830 Mode D'emploi

GB
COMMISSIONING
6.2.2
ASSEMBLY (FIG. 5)
Push the clamping lever (1) forwards to release the lock.
Remove the pump unit (3) at the container from the rotor (4).
Using the supplied specialised wrench, loosen the union nut
(5) on the pump unit (3) to separate the pump unit from the
pump tube (6).
Insert stator (7) in pump tube (6) such that the journal sits in
the largest recess.
824).
troller (9) to „0".
The operation light (10) shows operational readiness.
The red indicator light (11) flashes during the function check
for about 30 seconds.
Disconnect the remote control and exter-
nal controls. Only the person controlling
the machine may assemble the pump
unit.
Never operate mortar spraying machine
with an exposed rotor.
Do not reach into the rotor when it is
moving. Risk of crushing.
Caution if you have long hair. Only wear
close-fitting clothes at work.
Insert the pump unit (3) into the guide rails and push over the
rotor (4).
Hold on to the pump unit at the container.
Set the selector switch (8) to "R" and hold it there to allow the
As soon as the pump unit has reached the final position, re-
lease the selector switch (8).
Hook both hooks (2) into the pump unit and push the clamp-
ing lever (1) up as far as it goes to secure the pump unit.
After assembling the pump unit, secure the
union nut (5) on the pump unit, using the spe-
cialised wrench to do so. In the process, we
recommend running the machine at a slow
pace (selector switch on "F").
6.2.3

ASSEMBLING THE BAG SUPPORT (ACCESSORY)

Insert the bag support (fig. 6.1) into the holes at the top of the
PC830.
Secure from below using the 4 hex bolts.
38
1
-
11
10
POWER ERROR
8
Plast Coat 830
2
4
7
SPEED
9
1
5
3
6