WAGNER Plast Coat 830 Mode D'emploi page 44

GB
SHUTTING DOWN AND CLEANING
Dismantling
Mortar spraying machine must be depres-
surised.
If necessary, set the selector switch briefly
to "R" (reverse).
Watch the manometer ––> 0 bar.
Wear safety goggles.
Disconnect the remote control and exter-
nal controls. Only the person operating
the machine may remove the pump unit.
troller (2) to „0".
wrench (approx. a one-quarter turn)
(1) to position "F". As soon as the pump unit (5) has released,
move selector switch to "A" and remove pump unit.
Disconnect mains plug.
Cleaning the pump unit
Clean the pump unit (5) with a jet of water and a suitable bot-
tle brush.
Clean the container (8) with a jet of water and a suitable
brush.
Clean the protective grid with a radiator brush.
Also clean the rotor (9), stator (7) and pump tube (6) thor-
Clean the flat gasket (10).
lubricant.
Keep the thread of the pump housing and the pump tube
Mounting
Insert stator (7) in pump pipe (6) such that the journal sits in
the largest recess.
44
3 10
-
5
Plast Coat 830
POWER ERROR
SPEED
1 2
4
9
7
8
5
6