Connecting The Mortar Hose; Spray Attachment Assembly (Accessories) - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
6.3

CONNECTING THE MORTAR HOSE

6.3.1
AUTOMATIC SPRAY LANCE
Connect the mortar hose (Fig. 7, 1) and secure it with the
clamping levers (Fig. 7, 2).
Connect the atomizing air connection at the mortar hose
6.3.2
PNEUMATIC SPRAY LANCE
levers (Fig. 7, 2).
connection on handle (Fig. 8,1) and compressor air hose (ac-
6.4
COMPRESSOR (ACCESSORY)
Place the compressor at a secure location next to the mortar
Note:
operating manual.
6.5

SPRAY ATTACHMENT ASSEMBLY (ACCESSORIES)

Different accessories can be mounted to the
e.g. an extension can be attached. A precise
overview can be found in the "Accessories"
chapter.
Disengage the quick connector and pull the air hose (fig. 9,
1) out of the lance.
Loosen the locknut (2) and remove the material hose (3).
Insert the material hose and air hose (if available), which
Attention: Make sure the O-ring (fig. 10, 4) is not dam-
aged.
1
2
2
4
COMMISSIONING
1
2
3
1
GB
39