Sew Eurodrive X e Serie Notice De Montage Et D'exploitation page 258

Documentation fournisseur
11
9 Test mode
In the test mode the switching behaviour of the monitor can be checked, set and
stored without any connected pulse pick-up� The monitor runs through a freely
definable frequency range and switches the outputs according to the selected
switching function and switch points�
9.1 Activate the test mode
► Apply the operating voltage and press [Enter/►] simultaneously.
> The display indicates the parameter range 11 and "TST"�
> In addition to the system and application parameters, the parameters for the
test frequency are available�
Test parameters
1: Test frequency
2: Analogue output
3: Back to the test parameters
9.2 Terminate the test mode
► Switch off the unit�
22
258
Notice de montage et d'exploitation – Entraînements pour élévateurs à godets – Série X..e
Display mode
1
Input 1
[RPM/Hz]
SW1
TSx
TPx
TS1
2
Output 3
TP1
[mA]
System/application parameters
3