Sew Eurodrive X e Serie Notice De Montage Et D'exploitation page 245

2 [▲] and [▼] buttons
Selection of the actual value display, parameter selection, setting of the parameter
values
3 [Enter/►] button
Selection of the operating mode, acknowledgement of the parameter value, front
reset
4 LEDs In1/2 (yellow)
5 LEDs Out1/2 (green) Switching status of the outputs 1 and 2
Off
On
Flashing quickly
Flashing slowly
6 Panel for labelling
F���-xN = device with NAMUR input
4.1 Display stand-by mode
If no button is pressed for more than 10 minutes, the display changes to the stand-
by mode� Values and units are no longer visible�
The stand-by mode can be identified by a flashing rectangle�
Even if no values and units are visible, the device continues its monitoring
function on the basis of the set parameters and switches the relay and
transistor outputs accordingly�
Press any button to switch the display on again�
5 Installation
5.1 Installation of the device
► Install the device on a 35 mm DIN rail�
► Leave enough space between the unit and the top and bottom of the control
cabinet to enable air circulation and to avoid excessive heating�
► Take into account the internal heating of all units when mounting several units
side by side� The environmental conditions must be observed for every unit�
Notice de montage et d'exploitation – Entraînements pour élévateurs à godets – Série X..e
Input pulse
Output is not switched�
(Relay deenergised, transistor blocked)
Output is switched�
(Relay energised, transistor switched)
Output is kept latched�
(Parameter SOx, Store Output)
The delay time has an effect on the output�
The output switches when the delay time has elapsed and
the trigger event is still present (parameter DTx, Delay Time)
Documentation fournisseur
11
UK
9
245