Sew Eurodrive X e Serie Notice De Montage Et D'exploitation page 255

8 Programming
WARNING
If programming takes place during operation, dangerous contact voltage may
occur� Therefore ensure that programming is done by a qualified electrician�
Parameter changes during operation, especially changes to the switching
function and the switch points can lead to malfunction in the plant�
Therefore disconnect it during the change and then check the function�
Programming consists of 6 steps:
1� Change from the RUN mode to the parameter range 1 or 2 or 3
2� Selection of the requested parameter (FOx, SOx, NCx, etc�)
3� Change to the PRG mode
4� Setting or changing the parameter value
5� Acknowledgement of the set parameter value
6� Return to the RUN mode
8.1 Programming example DT1 (Delay Time, output 1)
Operation
Change from the RUN mode to the parameter range (here 1)
► Briefly press [Enter/►] once.
> The 1st parameter range is displayed�
Selection of the requested parameter (here DT1)
► Press the [▼] button until the parameter DT1 is displayed with
the currently set value (here default value 0�0)�
Change to the PRG mode
► Briefly press [Enter/►] once.
> The unit is in the programming mode�
> PRG indicator visible, parameter abbreviation flashes�
Notice de montage et d'exploitation – Entraînements pour élévateurs à godets – Série X..e
Documentation fournisseur
[Enter/►]
[▲] / [▼]
[Enter/►]
[▲] / [▼]
[Enter/►] > 3 s
[Enter/►] > 3 s
Display
CH1 RUN
1
CH1 RUN
1
CH1 RUN
1
CH1 RUN
0.0
DT1
CH1 RUN
0.0
DT1
CH1 RUN
0.0
CH1 RUN PRG
DT1
0.0
DT1
CH1 RUN PRG
0.0
DT1
CH1 RUN PRG
0.0
CH1 RUN PRG
DT1
15.0
DT1
CH1 RUN PRG
15.0
DT1
CH1 RUN PRG
15.0
CH1 RUN
DT1
15.0
DT1
CH1 RUN
15.0
19
DT1
CH1 RUN
15.0
CH1 RUN
DT1
1665
RPM
CH1 RUN
1665
RPM
CH1 RUN
1665
RPM
11
UK
255