Sew Eurodrive X e Serie Notice De Montage Et D'exploitation page 254

Documentation fournisseur
11
Default value
7.2.4 DTx
Delay Time (for outputs 1/2)
Enables a delayed switching of the outputs 1/2� The respective output switches only if the
current value is above or below the switch point for more than the time set here�
Values
Default value
7.2.5 FTx
Fleeting Time (for outputs 1/2)
If an event occurs, the output changes its state during the set time and then switches back
to the initial state�
Values
Default value
7.2.6 FA3
Final Value Analogue (for analogue output 3)
Input value in Hz or RPM at which the final value 20 mA is displayed or provided�
The output signal is limited to 20�5 mA�
Value range
Default value
18
254
Notice de montage et d'exploitation – Entraînements pour élévateurs à godets – Série X..e
0�0 (no start-up delay)
0�0���1000�0 s
0�0 (no delay time)
0�0���1000�0 s
0�0 (fleeting time not active)
0�1 ��� 1000�0 Hz or 1 ��� 60000 RPM (unit depends on DIM)
1000 RPM