Angelo Po 1N1FAEV Manuel D'utilisation page 54

ENGLISH
he appliance has been tested before being put
into service. The information provided below
is intended to assist in the identifi cation and
correction of any anomalies and malfunctions
which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical knowl-
edge or skill is required, and so they must only
be carried out by qualifi ed staff with recog-
nised experience acquired in the specifi c sector
of operation.
Faults
Smell of gas.
The pilot light goes out.
The fl ame is yellow.
Burner control knob is stiff .
The heating elements do not
come on
The appliance does not
heat up
to the set temperature
26
FAULT
TROUBLESHOOTING
For any need, please contact Angelo Po's
agents or headquarters, which can be
found in the contacts section of the website
www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
The thermocouple has not
warmed up enough.
Burner dirty.
Gas control valve
malfunction.
Electrical connection not
made correctly.
Safety thermostat tripped.
Switch faulty.
Thermostat faulty.
NOTE:
Remedies
Turn off the gas supply tap and
ventilate the room.
Make more attempts to light the
fl ame.
Clean the burner.
NOTE: Contact the after-
sales service.
Check the connection of the
electrical wires
NOTE: Contact the after-
sales service.
Carry out the appliance reset.
NOTE: Contact the after-
sales service.
Replace the switch
NOTE: Contact the after-
sales service.
Replace the thermostat
NOTE: Contact the after-
sales service.
3320060_ut_GB_rev.4
FAULT