Angelo Po 1N1FAEV Manuel D'utilisation page 53

SERVICING
CLEANING THE HOB, BURNERS AND ACCESSORIES
Avoid leaving the components dirty for long
and, periodically,according to the intensity of
work (if necessary daily),proceed as indicated
below:
Switch the appliance off and leave it to cool.
)
Remove the grill, the burner cap (A) and the
)
burner (B).
Put them to soak in hot water with dishwash-
)
er soap.
Wash with a normal sponge and if necessary
)
a scourer to remove any dirt thoroughly.
Check that the holes of the burner cap (A) are
)
always completely clear for the regular fl ow
of gas. To remove possible dirt, insert a metal
rod (wire) into the hole and slide it through
until it is thoroughly clean.
Check the burner (B) ignition slot (cutoff ) is
)
always completely clear for the normal fl ow
of gas. To remove any dirt, insert a blade like
a trimming knife in the slot, sliding it around
until it is thoroughly clean.
Carefully clean all the connecting parts be-
)
tween the burner cap (A) and the burner (B).
If necessary use a steel wire brush for me-
chanics.
Clean every part of the hob with a suitable
)
de-greaser.
To carry out this operation, proceed as follows.
Remove the bottom plate (A) and the grid (B)
)
from the oven and clean them thoroughly.
Clean the inside parts of the oven to remove
)
any deposits which may impair its opera-
tion.
Dry the surfaces and reassemble the compo-
)
nents.
3320060_ut_GB_rev.4
Dry the surfaces and reassemble the parts.
)
For the correct assembly of the burner (B) and
burner cap (A), follow the directions given in
the illustration.
Turn on the burners for a few minutes to
)
ensure a thorough drying and thus avoiding
the formation of rust.
WARNING: Do not wash cast iron
parts such as the burners, burner caps and
grids in a dishwasher.
WARNING: Never pour water or allow
dirt to fall into the burner as this will cause a
fault in the burner or block the nozzle.
CLEANING OVEN
B
A
ENGLISH
A
B
25