Publicité
EN
Charging the starting battery using the house battery
NOTE The jump start function can only be activated when the battery charger is not connected to an AC
source, no D+ signal is present and the house battery voltage is more than 11.8 V.
Press the jump starter and house battery type selector button
charging.
The starting battery is charged for 10 min from the house battery.
NOTE After 10 min, the process can be repeated by pressing the jump starter and house battery type
selector button
11 Cleaning and maintanance
WARNING! Electrocution hazard
Disconnect the batteries before cleaning and maintenance.
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach during cleaning as these can
damage the device.
Occasionally clean the device with a so, damp cloth.
Regularly check live cables or lines for insulation faults, breaks or loose connections.
Regularly clean the vents.
12 Troubleshooting
Problem
The battery charger does not work.
The battery charger stops the charging
process.
The full charge current is not reached.
20
(Fig.
on page 11, 7) again.
Possible cause
Insulation faults, breaks or loose con-
nections at the live cables.
A short circuit has been generated.
The battery is defective.
The battery terminals are not connect-
ed correctly.
(Fig.
on page 11, 7) for at least 2 s to start
Suggested remedy
Check the live cables for insula-
tion faults, breaks or loose con-
nections.
If no error can be found, contact
an authorized service agent.
The battery charger fuse must be
replaced. Contact an authorized
service agent.
Replace the battery.
Check the connections.
Ensure the cable cross-section is
suitable for 30 A.
Publicité
