nanny BM-02 Mode D'emploi page 6

EN
We recommend contacting a doctor depending on the circumstances. In some cases the alarm
signal itself rouses the baby strongly enough to make her take a breath. To turn the alarm off, press
the switch on the evaluation unit. Exceptionally, a false alarm may occur, which is the case especially
when the sensor pad is not fi tted properly (see the Installation Instructions and the Frequently Asked
Questions) or when the baby can crawl and moves outside the reach of the sensor pad inside the crib.
We hope you hear the alarm signal only once: when testing our product.
A sensor pad can be bought as a separate item. It is available under item No. BM-02D.
o
It is extremely handy when the device is used in several places; e.g. in another crib, at grandma's,
o
etc. In this case the evaluation unit is the only thing you have to remember to take along.
The sensor pad may be placed in incubators by health care providers.
o
Warning:
Never use another type of sensor pad or those from other manufacturers, nor the BM-02D sensing
mat in combination with another type of product from another manufacturer.
Check the operation of the device as follows (recommended testing frequency is once a week):
1. When the baby is in the crib and the BM-02 is on, the green indicator must fl icker with the rhythm of
the baby's breath.
2. Leave the BM-02 on and take the baby out of the crib. The indicator usually keeps fl ickering for a while
until the crib stops shaking. Do not hold on to the crib because the BM-02 could detect your breath
and movements.
3. When the crib has been still for about 20 seconds the evaluation unit gives off a warning beep and
then an alarm signal is activated. While the alarm is on, the red indicator keeps fl ickering. The alarm
can be turned off with the switch.
If the BM-02 does not work check whether:
1. The evaluation unit confi rms the activation of the BM-02 by a low beep and fl ickering. If it does not,
check the batteries.
2. The green indicator stops fl ickering after taking the baby out of the crib. If it does not, the BM-02
detects disturbing vibrations – see the following information.
Important information:
o The device uses a highly sensitive sensor to detect breathing. Its operation can be affected by shakes
of the crib, fl oor or the whole building especially in the home health care environment. This is why the
crib must not touch a bed in which somebody is sleeping or other equipment that vibrates. Interfering
shocks can also be caused by intensive air circulation (fans, air conditioning, etc.), people walking near
the crib and other factors. If you move the crib to a new place or if you turn on a new appliance that
generates mechanical vibrations or electromagnetic interference, we recommend that you test the de-
vice's functioning. Wireless communication technology devices such as wireless home networks, mobile
phones, cordless phones and their base stations, mobile stations, which may adversely affect the baby
and affect the functionality and usability of the BM-02 should not be used closer than 1 m, nor should
6
MFV52124
(859405253BM02ES)
Sensor pad
Function test