Publicité
Les langues disponibles
Les langues disponibles
EN
Warning:
The BM-02 does not prevent the occurrence of sleep apnea in an infant! If operated and used in accor-
dance with this manual, the monitor is unlikely to fail.
1. Place the sensor pad into the crib (pram, Moses basket, etc.) under the mattress (or cushion)
underneath the area where the baby will be sleeping – see the fi gure.
o
The center of the sensor pad should be approximately where the baby's chest is.
o
The pad should be placed on an even fi rm surface
with the printed side facing up – It must not be bent!
o
If there is only a bed frame in the crib, place a fi rm
board under the sensor pad; e. g. hardboard,
plywood, etc. The base board should not cover the
whole crib surface so as not to prevent air circulation
– its satisfactory size overhangs the sensor pad by
approx. 3 cm on each side.
o
For further installation advice and instructions read
page 8, Frequently Asked Questions.
Note:
When using the BM-02 for twins it is absolutely necessary that each baby has its own crib provided with
an independent baby monitor. To ensure correct signal evaluation the cribs must not touch each other.
2. Insert batteries into the device (the battery compartment cover is on the back of the device).
o
To remove the battery compartment cover, push its straight edge gently and move it towards the round
edge – see Fig. A.
o
Insert batteries. Only use new alkaline batteries - AA LR6 type (do not use
rechargeable batteries). The polarity of batteries is clearly marked in the
battery compartment.
o
Seal the battery compartment cover and turn the switch to position I.
o
If the batteries are in good condition, all 3 indicators will fl ash one after
another and you will hear a beep.
o
If there is no beep after turning the unit ON, check the batteries.
o
Wait approx. 3 seconds before turning the unit on again – after turning the
unit on its electronic system checks the batteries and functions.
o
The unit must be clearly visible and must not be covered by anything – see
Fig. B.
o
If the evaluation unit has to be mounted outside the crib, extend its cable by
means of the splitting connector and the 5 m long cable (both are included
in the supply).
o
When used for a bigger baby, mount the unit outside
her reach.
o
It is also possible to attach the unit on the wall by
means of a plastic holder (included in the supplied
items).
3. Connect the sensor pad's cable to the evaluation
unit. When connected properly, the connector clicks
and is fi rmly attached.
4
MFV52124
(859405253BM02ES)
Installation instructions
Fig. A
Fig. B
Publicité
