KUMATSUGEN GM2500 Mode D'emploi page 8

EN
Periodic Inspection And Service
The following table is given as a guideline for periodic maintenance procedures.
These inspections and services are recommended for outboard motors used on an average of 20 hours per month. Depending
on operating conditions, the intervals between maintenance procedures may need to be changed.
Instructions on refuelling
The gasoline is highly flammable and explosive:
1. Don't smoke,when refuelling,keep away from fire,flame and ignitions of other sources.
2. Shut off the engine of your outboard engine before refuelling.
3. Use unleaded gasoline only. Use 4 stroke engine oil.
4. Don`t spill the gasoline. Use clean cloth wipe off the spilled gasoline.
5. When start the engine, keep at least 3 meters distance from the refuelling point.
Maintenance work / Interval
Run engine in fresh water.
Fuel filter: Check and clean.
Spark plugs: Check condition and change if necessary.
Propeller: Pull off and clean propeller shaft.
Zinc anode: Pull off and scrub clean.
Engine head: Flush with fresh water, clean, spray with crc and
apply grease.
Engine lubrication: Apply grease to the specified points.
Fuel tank: Clean with detergent and fresh water.
Crankcase: Drain and refill with oil.
Impeller: Replace impeller and apply grease to the crankshaft.
Caution! For safety reasons the propeller system is supplied with no lubricant during delivery, please install angle
transmission grease before operating the machine.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior
notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated
in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line
with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement
work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause
malfunctions or even serious injury or death. The manufacturer and the importer shall not be liable for injuries and damages
resulting from the use of non-conforming equipment.
8
month
WWW.NIKOLAOUTOOLS.COM
Every Every 3 Every 6
months months
Χ
Χ
Χ
Χ
Χ
Χ
Χ
Χ
Χ
Every 2
Every year
years
Χ