Publicité
Les langues disponibles
Les langues disponibles
EN
Starting and Stopping the Engine
Starting the engine
•
Turn the engine switch to the "on"(on the equipment side).
•
To start a cold engine, move the choke lever to the close position.
•
Press the primer bulb several times until a fuel flow in the fuel return is visually noticed.
•
Pull the starter grip lightly until resistance is felt, then pull briskly, returned the starter grip gently.
•
Turn the chock lever to the open position, as the engine warm up.
Stopping the engine
Move the throttle lever to the slowest position(on the equipment side) turn the engine switch to the "off" position(on the
equipment side).
Set the throttle lever at the desired position(on the equipment side).
Maintenance
Maintenance Schedule
1: Check 2: Clean 3: Replace if necessary 4: Change 5: Check-Readjust
This product should be serviced by professional people!
Oil Change
Remove the oil filler cap.
Drain the oil by tilting the engine.
Fill the oil to the edge of the oil filler neck.
Install the oil filler cap.
Spark Plug
Loosen 5mm hex bolt, then remove the top cover do not pull the starter grip and start the engine when the top cover
removed.
Remove the spark plug cap.
Clean the deposit.
Measure the clearance.
Fuel Filter Service
Remove the spark plug.
Drain the fuel by tilting the engine.
Pull out the fuel filter and clean it gently.
Fuel tank cleaning
Remove the fuel filler cap.
Drain the fuel by tilting the engine.
Pull out the fuel filter and remove water and dirt stood in the fuel tank buy rinsing its inside.
Cooling Fin (Available on some models)
Check the cooling fin of its dirt through the fin cover.
Fuel Tube
Check the fuel tube and the fuel return tube of its deterioration.
Storage
Drain the fuel from the fuel tank.
Press the priming pump several times and drain the fuel from the fuel tank again.
Remove the oil filler cap and drain the oil.
Fill the oil to the edge of the oil filler neck.
Store the engine in a clean area.
3
WWW.NIKOLAOUTOOLS.COM
Publicité
