KUMATSUGEN GM2500 Mode D'emploi page 5

EN
Trim Angle
By changing the outboard motor's drive angle, the vessel's bow can be made to rise or fall. The performance and stability of
a vessel depends a great deal on correctly trimming the outboard. The correct trim angle depends on the vessel's handling
characteristics, the size of the outboard, the sea and loading conditions. Care must therefore be taken to ensure the outboard
is trimmed correctly under different sea and loading conditions. On smaller outboards, the trim angle is adjusted manually by
moving an adjusting rod to different holes in the mounting bracket. The bigger outboards usually have a Trim Switch fitted
on the remote control lever.
Install the part 27 as the above picture, shows. Before assembly, loose the part 37, fix the part 27 and 38 by tool 41, assembly
the 4pcs part 42 as the above picture shows. Then fasten part 42 and part 37. Make sure the part 37 can move appropriately
after part 37 and 42 been fastened.
5
Loosen 2 screws 37 in
the above picture to
adjust the angle of the
outboard motor.
WWW.NIKOLAOUTOOLS.COM
Install the well-assembled outboard engine to the
board of the boat. Fix it tight.
Insufficient angle Correct angle Excessive angle