Vortice VORT HRI 200 PHANTOM BP IoT Notice D'emploi Et D'entretien page 60

ENGLISH
C
Heaters settings
Service settings > Heaters settings
Minimum supply fan control with pre-heater 20%
9.4.3 P rogramming
From the programming page, it is possible to set different time slots for each day of the week with different bypass setpoint
temperatures ("Working mode temperature") and different appliance operating modes (working modes "1, 2 ,3" corresponding to the
three appliance speeds and the "pause" mode during which the appliance is switched off).
Steps to follow:
1. Select the day of the week you wish to program.
2. Select the desired working mode.
3. Click on the start time of the desired time slot.
4. Set the end time of the time slot. You can also set the minutes (in 30-minute intervals) of both the start and end time of each time
slot.
5. Set the desired working mode temperature (=bypass setpoint temperature).
6. Press the "Confirm" button.
7. Repeat steps 1 to 6 for the other days of the week you wish to program.
Selected schedule
MONDAY TUESDAY
1
Work mode: Work mode 1
1
1
3
Note: Switching to Wi-Fi mode and via the Cloud, selecting the "Program" icon from the main page will take you to the programming
page (refer to paragraph"9.2 Operation from the Vorticenet cloud via browser (Wi-Fi connection)").
60
mon..
WEDNESDAY
2
8 °C
D
Modbus settings
Service settings > Modbus settings
Modbus address
Transmission speed
Number of stop bits
Modbus activation
Edit parameters
Ventilation unit control
Selected schedule
mon.
MONDAY MONDAY WEDNESDAY
Range setting
02:30
Start:
06:30
End:
Work mode:
Work mode 1
4
1
Temperatura della modalità di lavoro 1
20.0 °C
5
30 °C
Confirm
6
1
115200
1 stop bit
Yes
Yes
Yes
Selected schedule
MONDAY TUESDAY
Work mode 1
Work mode:
1
Work mode 1
1
mon.
WEDNESDAY