Vortice VORT HRI 200 PHANTOM BP IoT Notice D'emploi Et D'entretien page 46

ENGLISH
8.1.5 Boost mode setting
1. Select "Boost mode setting" in
the "Service settings" menu.
Device settings
SERVICE SETTINGS
Information
User modes settings
Fans settings
Heaters settings
Filter settings
Frost protection settings
Boost mode settings
Modbus settings
8.1.6 Frost protection setting
1. Select "Frost protection setting"
in the "Service settings" menu.
Device settings
SERVICE SETTINGS
Information
User modes settings
Fans settings
Heaters settings
Filter settings
Frost protection settings
Boost mode settings
Modbus settings
46
2. Set "Normally open" or
"Normally closed" by clicking on
the pencil symbol next to "Logic
status IN1".
Boost mode settings
Service settings > Boost mode settings
Boost mode IN1 Logic state
Normally Open
Supply fan control from IN1 100%
Extraction fan control from IN1 100%
2. To enable or disable pre-heater
operation, set "Yes" or "No" next
to "Pre-heater enabled".
Frost protection settings
Service settings > Frost protection settings
Frost protection enabled
On
Initial fan settings
Work modes
Pre-heater enabled
Yes
Frost protection activation temperature 3°C
Frost protection disactivation hysteresis
3°C
Supply fan speed change
Yes
Minimum supply fan control 30%
Boost mode IN1 Logic state
NORMALLY OPEN
NORMALLY CLOSED
Confirm
3. To enable or disable flow
unbalance, set "Yes" or "No"
next to "Supply fan speed
change".
Frost protection settings
Service settings > Frost protection settings
Frost protection enabled
On
Initial fan settings
Work modes
Pre-heater enabled
Yes
Frost protection activation temperature 3°C
Frost protection disactivation hysteresis
3°C
Supply fan speed change
Yes
Minimum supply fan control 30%