Suzuki DF9.9B Manuel Du Propriétaire page 30

OIL CHANGE REMINDER
SYSTEM
This system informs the operator of the time for
replacing engine oil on the basis of the mainte-
nance schedule.
The system is designed to register the total
operating hours of the outboard motor and
function its operation when the preprogrammed
hours have reached.
(Refer to the INSPECTION AND MAINTE-
NANCE section and the last page.)
SYSTEM ACTIVATION
TILLER HANDLE MODEL
When the total operating hours have reached
the preprogrammed hours, the caution lamp will
flash while the engine is running. This indication
will repeat until you cancel the system activa-
tion.
REMOTE CONTROL MODEL
When the total operating hours have reached
the preprogrammed hours, the caution lamp will
flash. This indication will repeat until you cancel
the system activation.
CANCELLATION
TILLER HANDLE MODEL
1. Start the motor.
Make sure that the motor is in "Neutral" and
the throttle grip is fully closed.
NOTE:
The engine stops when the engine stop button
is kept to push more than 0.5 seconds.
2. Push the engine stop button 1 three times
within three seconds so that the engine
should not stall.
The caution lamp is no longer lit when the
reminder cancellation is successful.
28
3. Stop the engine.
REMOTE CONTROL MODEL
1. Sift into "NEUTRAL".
2. Turn the ignition key to the "ON" position.
3. Pull out the emergency stop switch plate 1.
4. Pull up the emergency stop switch knob 2
three times within 4 seconds. The caution
lamp is no longer lit when the reminder can-
cellation is successful.
5. Turn the ignition key to the "OFF" position.
6. Set the plate 1 in the original position.
NOTE:
• Canceling of the system activation is possible
regardless of whether or not the engine oil
has been replaced. Once the system has
operated, however, Suzuki strongly recom-
mends that the engine oil be replaced before
canceling the system activation.
• Even if the engine oil has been replaced with
the system not operating, it is still necessary
to perform the cancellation.